萘
-
丙酮中水合三氯乙醛(以三氯乙醛计)
NCS1600174-D | 1000μg/mL
-
玉米粉中T-2毒素分析质控样品
NCS190287-1 | 见证书
-
甲醇中氟苯尼考溶液标准物质
NCS1602905-100A | 100μg/mL
-
玉米粉中呕吐毒素分析质控样品
NCS190274-5 | 见证书
-
玉米粉中T-2毒素分析质控样品
NCS190287-3 | 见证书



Reference Material
This certificate is designed in accordance with ISO17034 and ISO Guide 31. This reference material (RM) was designed,produced andverified in accordance with ISO/IEC 17025, ISO 17034 and a registered qualitymanagement system ISO9001.
Product Name
Naphthalene
Product Code
BW901062
Lot Number
23071541
CAS No.
91-20-3
Mol. Formula
C10 H8
Mol. Weight
128.17
Certified on
21 Jul 2023
Expiry Date
20 Jul 2028
Storage Temp
20°C ± 4°C
Specification
250mg
CERTIFIED
Purity
CERTIFIED
Expanded Uncertainty (U)
Approved by
99.6%
1.0%
Method of Characterisation
GC/FID
Batch Information
Water Content: <0.1% (by Karl-Fischer-Titration)
Uncertainty
The certified value(s) and uncertainty(ies) aredetermined in accordance with ISO 17034 with an 95% confidence level (k=2).Uncertainty is based on the Total Combined Uncertainty, including uncertaintiesof characterisation, homogeneity and stability testing. Stability values are basedon real evidence opposed to simulation.
The producer certifies that this reference materialmeets the specification stated in this certificate until the expiry date,provided it is stored unopened at the recommended temperature herein. Productwarranties for this reference material are set out in the terms and conditionsof purchase.
Intended Use
This RM is intended for use in a laboratory as acalibration and quality control standard or in method development foranalytical techniques.
Safety
Proper precautions should be observed whilehandling. See Safety Data Sheet.
Traceability
The balances used for gravimetric measurements arecalibrated with weights traceable to the national standards (DKD). Thecalibration of the balances is verified daily internally and annually by anexternal7 accredited calibration service. Chromatographic methods are traceableto the International System of Units (SI).
Homogeneity
Random replicate samples of the final packaged RMhave been analysed to prove homogeneity compliant with ISO 17034.
Storage
The RM should be stored in the original sealedcontainer at the indicated temperature.
Instructions for use
It is recommended to use 1 mg as the minimum samplesize and if less material is used, to increase the certified uncertainty by afactor of two for half sample and four for a quarter of sample. If storageafter opening is necessary, the RM should be tightly closed and kept from lightand moisture. If the RM was in a sealed ampoule, it should be transferred to avial with minimum head space.
您正在浏览的产品:萘
手机版:萘
本公司销售的所有产品仅供实验科研使用,不用于人体及临床诊断。
2. 仪器条件:色谱柱为HP-5MS(30 m × 0.25 mm × 0.25 μm),柱温程序为40℃保持2 min,以10℃/min升至280℃,保持5 min。
2. 定量限(LOQ):0.03 μg/L(以信噪比≥10计),具体数值需通过标准曲线验证。
2. 平行样相对偏差应≤20%,加标回收率控制在70%-120%。
2. 洗脱与浓缩:用乙酸乙酯洗脱目标物,氮吹浓缩至0.5 mL,进样前过0.22 μm有机滤膜。
2. 实验过程中需全程避光,防止有机物光解。
3. 若检测结果超出线性范围,需稀释后重新测定。
以上信息仅供参考,请以相应标准的原文为准!