• 欢迎来到萘析商城
正庚烷_142-82-5,正庚烷
图片仅供参考,具体产品以实物为准!

正庚烷

BW901020 {{goodObj.price > 0 ? '¥' + goodObj.price : '咨询'}} ¥{{goodObj.sell_price || 0}} 咨询 142-82-5 1mL {{goodObj.date}} 秦境 {{item.norm}} 99.0% {{inventory}}
正庚烷介绍:

Reference Material

This certificate is designed in accordance with ISO17034 and ISO Guide 31. This reference material (RM) was designed,produced andverified in accordance with ISO/IEC 17025, ISO 17034 and a registered qualitymanagement system ISO9001.

Product Name

n-Heptane

Product Code

BW901020

Lot Number

23041519

CAS No.

142-82-5

Mol. Formula

C7H16

Mol. Weight

100.20

Certified on

14 Apr 2023

Expiry Date

13 Apr 2025

Storage Temp

(0~4)°C

Specification

1 mL

CERTIFIED

Purity

CERTIFIED

Expanded Uncertainty (U)

Approved by

99.0%

0.5%

Uncertainty

The certified value(s) and uncertainty(ies) aredetermined in accordance with ISO 17034 with an 95% confidence level (k=2). Uncertaintyis based on the Total Combined Uncertainty, including uncertainties ofcharacterisation, homogeneity and stability testing. Stability values are basedon real evidence opposed to simulation.

The producer certifies that this reference materialmeets the specification stated in this certificate until the expiry date,provided it is stored unopened at the recommended temperature herein. Productwarranties for this reference material are set out in the terms and conditionsof purchase.

Intended Use

This RM is intended for use in a laboratory as acalibration and quality control standard or in method development foranalytical techniques.

Safety

Proper precautions should be observed whilehandling. See Safety Data Sheet.

Traceability

The balances used for gravimetric measurements arecalibrated with weights traceable to the national standards (DKD). Thecalibration of the balances is verified daily internally and annually by anexternal accredited calibration service. Chromatographic methods are traceableto the International System of Units (SI).

Homogeneity

Random replicate samples of the final packaged RMhave been analysed to prove homogeneity compliant with ISO 17034.

Storage

The RM should be stored in the original sealedcontainer at the indicated temperature.

Instructions for use

It is recommended to use 1 mg as the minimum samplesize and if less material is used, to increase the certified uncertainty by afactor of two for half sample and four for a quarter of sample. If storageafter opening is necessary, the RM should be tightly closed and kept from lightand moisture. If the RM was in a sealed ampoule, it should be transferred to avial with minimum head space.


您正在浏览的产品:正庚烷

手机版:正庚烷

本公司销售的所有产品仅供实验科研使用,不用于人体及临床诊断。

国家标准1: GB/T 1884-2000《石油和液体石油产品密度测定法》
适用范围 适用于液体石油产品(包括正庚烷)在实验室条件下的密度测定,适用于透明、低黏度液体的密度计算。
核心检测方法 采用密度计法,在恒温条件下(通常为20℃)将样品注入量筒,插入密度计读取密度值,结合温度修正系数计算最终结果。
检出限与定量限 本标准不涉及化学分析,检出限与定量限不适用,密度测量精度可达0.0001 g/cm³。
质控样品要求 需使用经认证的标准物质(如高纯度正庚烷)进行仪器校准,确保测量环境恒温且无振动干扰。
关键实验步骤 1. 样品恒温至20℃;
2. 注入清洁量筒至80%体积;
3. 插入密度计并稳定后读数;
4. 记录温度并修正数据。
特别说明 实验需在无风环境下进行,防止密度计偏移;正庚烷易挥发,操作需快速且密封保存样品。
行业标准1: SH/T 0246-1992《溶剂油芳烃含量测定法》
适用范围 适用于含正庚烷的溶剂油中芳烃含量的测定,通过色谱分析分离正庚烷与其他烃类组分。
核心检测方法 气相色谱法(GC),使用非极性色谱柱(如SE-30)分离样品中的烷烃、芳烃,通过面积归一化法计算含量。
检出限与定量限 芳烃组分检出限为0.01%(质量分数),定量限为0.05%;正庚烷作为溶剂基质时需扣除背景干扰。
质控样品要求 每批次检测需包含空白样品(纯正庚烷)及已知浓度的芳烃标准溶液进行校准曲线验证。
关键实验步骤 1. 样品稀释至适宜浓度;
2. 设定色谱柱温箱程序(初始50℃,升温至280℃);
3. 进样并采集数据;
4. 峰面积积分与结果计算。
特别说明 正庚烷纯度需≥99%,避免杂质峰干扰;实验结束后需高温老化色谱柱以去除残留组分。
国家标准2: GB/T 7534-2020《工业用挥发性有机液体 沸程的测定》
适用范围 用于测定正庚烷等挥发性有机液体的初馏点、干点及沸程范围,评估其纯度及挥发性。
核心检测方法 蒸馏法,使用标准蒸馏装置加热样品,记录第一滴馏出物(初馏点)和最终残留液温度(干点)。
检出限与定量限 温度测量精度需达0.1℃,沸程范围测定误差不超过±1℃。
质控样品要求 使用已知沸程的正庚烷标准品(如沸点98-100℃)验证设备准确性,每10次实验校准一次。
关键实验步骤 1. 装置气密性检查;
2. 样品量取100mL;
3. 控制加热速率(4-5mL/min);
4. 记录温度并绘制蒸馏曲线。
特别说明 正庚烷易燃,需远离明火;蒸馏残渣需按危险废物处理,避免环境污染。

以上信息仅供参考,请以相应标准的原文为准!