丙酸
-
乙腈中三唑磷标准品
NCS1601335-100B2 | 100ug/mL
-
水中2'-岩藻糖基乳糖(2'-FL)溶液
NCSG1603380-10000C | 10mg/mL
-
水中乳糖-N-新四糖(LNnT)溶液
NCSG1603385-3000C | 3000μg/mL
-
水中昆布三糖溶液
NCSG1603694-2000C | 2000ug/mL
-
二氯甲烷甲醇中MK-9溶液
NCS1603698-500A | 0.5mg/mL



REFERENCE MATERIAL CERTIFICATE
Reference Material
This certificate is designed in accordance with ISO 17034 and ISO Guide 31. This reference material (RM) was designed,produced and verified in accordance with ISO/IEC 17025, ISO 17034 and a registered quality management system ISO9001.
Product Name
Propionic acid
Product Code
BW901101
Lot Number
25101514
CAS No.
79-09-4
Mol. Formula
C3H6O2
Mol. Weight
74.08
Certified on
27 Oct.2025
Expiry Date
26 Oct. 2030
Storage Temp
20°C ± 3°C
Specification
1g
CERTIFIED
Purity
CERTIFIED
Expanded Uncertainty (U)
Approved by
99.5%
1.0%
Uncertainty
The certified value(s) and uncertainty(ies) are determined in accordance with ISO 17034 with an 95% confidence level (k=2). Uncertainty is based on the Total Combined Uncertainty, including uncertainties of characterisation, homogeneity and stability testing. Stability values are based on real evidence opposed to simulation.
The producer certifies that this reference material meets the specification stated in this certificate until the expiry date, provided it is stored unopened at the recommended temperature herein. Product warranties for this reference material are set out in the terms and conditions of purchase.
Intended Use
This RM is intended for use in a laboratory as a calibration and quality control standard or in method development for analytical techniques.
Safety
Proper precautions should be observed while handling. See Safety Data Sheet.
Traceability
The balances used for gravimetric measurements are calibrated with weights traceable to the national standards (DKD). The calibration of the balances is verified daily internally and annually by an external accredited calibration service. Chromatographic methods are traceable to the International System of Units (SI).
Homogeneity
Random replicate samples of the final packaged RM have been analysed to prove homogeneity compliant with ISO 17034.
Storage
The RM should be stored in the original sealed container at the indicated temperature.
Instructions for use
It is recommended to use 1 mg as the minimum sample size and if less material is used, to increase the certified uncertainty by a factor of two for half sample and four for a quarter of sample. If storage after opening is necessary, the RM should be tightly closed and kept from light and moisture. If the RM was in a sealed ampoule, it should be transferred to a vial with minimum head space.
您正在浏览的产品:丙酸
手机版:丙酸
本公司销售的所有产品仅供实验科研使用,不用于人体及临床诊断。
2. 加标回收样品:添加已知浓度丙酸标准溶液,回收率应为80%-120%;
3. 平行样测试:每组样品至少设置2个平行样,相对偏差≤10%。
2. 衍生化(可选):部分方法需将丙酸与衍生试剂(如BSTFA)反应,提高检测灵敏度;
3. 色谱条件:填充柱或毛细管柱(如HP-FFAP),检测器为氢火焰离子化检测器(FID),程序升温;
4. 定量分析:根据标准曲线计算含量,注意基质效应校正。
2. 若采用直接进样法,需确保样品溶液洁净,避免污染色谱系统;
3. 实验过程中应佩戴防护用具,避免丙酸对皮肤及呼吸道的刺激。
以上信息仅供参考,请以相应标准的原文为准!