• 欢迎来到萘析商城
2-丁酮_78-93-3,丁酮
图片仅供参考,具体产品以实物为准!

2-丁酮

BW901025 {{goodObj.price > 0 ? '¥' + goodObj.price : '咨询'}} ¥{{goodObj.sell_price || 0}} 咨询 78-93-3 100mg {{goodObj.date}} 秦境 {{item.norm}} 99.5% {{inventory}}
2-丁酮介绍:

Reference Material

This certificate is designed in accordance with ISO 17034 and ISO Guide 31. This reference material (RM) was designed,produced and verified in accordance with ISO/IEC 17025, ISO 17034 and a registered quality management system ISO9001.

Product Name

2-Butanone

Product Code

BW901025

Lot Number

25051516

CAS No.

78-93-3

Mol. Formula

C4H8O

Mol. Weight

72.11

Certified on

12 May 2025

Expiry Date

11 May 2030

Storage Temp

(0~4)°C

Specification

100 mg

CERTIFIED

Purity

CERTIFIED

Expanded Uncertainty (U)

Approved by

99.5%

1.0%

Uncertainty

The certified value(s) and uncertainty(ies) are determined in accordance with ISO 17034 with an 95% confidence level (k=2). Uncertainty is based on the Total Combined Uncertainty, including uncertainties of characterisation, homogeneity and stability testing. Stability values are based on real evidence opposed to simulation.

The producer certifies that this reference material meets the specification stated in this certificate until the expiry date, provided it is stored unopened at the recommended temperature herein. Product warranties for this reference material are set out in the terms and conditions of purchase.

Intended Use

This RM is intended for use in a laboratory as a calibration and quality control standard or in method development for analytical techniques.

Safety

Proper precautions should be observed while handling. See Safety Data Sheet.

Traceability

The balances used for gravimetric measurements are calibrated with weights traceable to the national standards (DKD). The calibration of the balances is verified daily internally and annually by an external accredited calibration service. Chromatographic methods are traceable to the International System of Units (SI).

Homogeneity

Random replicate samples of the final packaged RM have been analysed to prove homogeneity compliant with ISO 17034.

Storage

The RM should be stored in the original sealed container at the indicated temperature.

Instructions for use

It is recommended to use 1 mg as the minimum sample size and if less material is used, to increase the certified uncertainty by a factor of two for half sample and four for a quarter of sample. If storage after opening is necessary, the RM should be tightly closed and kept from light and moisture. If the RM was in a sealed ampoule, it should be transferred to a vial with minimum head space.


您正在浏览的产品:2-丁酮

手机版:2-丁酮

本公司销售的所有产品仅供实验科研使用,不用于人体及临床诊断。

匹配的国家标准解读
标准名称及标准号 GBZ/T 300.65-2017《工作场所空气有毒物质测定 第65部分:丁酮、甲基异丁基甲酮和双乙烯酮》
适用范围 适用于工作场所空气中2-丁酮(含其他酮类化合物)的短时间采样和长时间采样检测,覆盖蒸气态和颗粒物混合态样本。
核心检测方法 溶剂解析-气相色谱法:采用活性炭管采样,二硫化碳解析后经毛细管色谱柱分离,氢火焰离子化检测器(FID)定量分析。
检出限与定量限 检出限(LOD)为0.5 μg/mL,定量限(LOQ)为1.7 μg/mL(按采样体积3L计,对应空气中最低定量浓度为0.56 mg/m³)。
质控样品要求 每批次样品需包含空白对照、平行样和加标回收样,平行样相对偏差≤15%,加标回收率控制在85%-115%。
关键实验步骤 1. 样品采集:活性炭管以0.5 L/min流量采样15分钟
2. 解析处理:加入1 mL二硫化碳震荡解析30分钟
3. 仪器分析:进样量1 μL,柱温程序升温(初始50℃保持2分钟,以10℃/min升至150℃)
特别说明 1. 二硫化碳需经二次蒸馏纯化
2. 采样后需在4℃冷藏保存并7日内完成分析
3. 色谱分离需确保与甲基异丁基甲酮等同类物完全分离

以上信息仅供参考,请以相应标准的原文为准!